CARLSON LABEL ANGLE

[peter-lothian]

Annotate Defaults – under the Angle tab

[[email protected]]

okay I looked there and tried to change setting but it seemed not to take- Select Deg and 0?

[Jon Payne]

Pull down Annotate-Label Angle

Command line should show ‘Define angle by …”

Select “O” for options

Check box beside “Decimal Degrees”

Then “Decimal Places” should become available to fill in.

Select 0 for degrees only

• This reply was modified 9 months, 3 weeks ago by  Jon Payne.

[Kris Morgan]

Annotation>Annotate Defaults>Angle>Deg.Min.Sec. and then select the precision.

[Spatialwerks]

You could also try, from the pull-down menu; Draw, Dimension Style, Modify, then on the Primary Units tab towards the bottom right on the Angular Formats section change the Unit Formats and Precision.