While walking in the woods while hunting, the hunter may not even know that he has entered private lands. I doubt it very much that private owners of ...

whatever software you plan to use it on, get their recommended ram and get 1.5x or 2x if not out of your budget. you won't be bogged down by paging fi...

@bill93 yes, I have the raw logs from both the base & rover. These were what I used to post processed (PPK) but using 2 post processing software,...

I have always been looking at Asus, Dell, HP when planning to buy a new laptop but have always settled on the Lenovo Thinkpad line. It must be the sta...

But how many of us can afford the extra time to recheck even just every 10% of all points surveyed. It is similar to TS shots where you just shoot as ...

@mightymoe LLH, actually I am comparing the H values and roughly converting the LL differences.?ÿ

@rover83 I used 2 post-processing software to compare the kinematic results. Magnet & RTKLib. Both returned different values for the same timesta...

@nate-the-surveyor Thanks for the reply. We were doing a topo in relatively low wooded areas. We completed a section of the site last week. Yesterday...

So Chicago has a reputation for Bad surveyors hence the post title?

Also ask yourself, if someone else is going to check your work, will they go through the same process? get the same errors? get worse results? ?ÿ

Maybe try trigonometric leveling or GPS readings, RTK, or static to transfer elevations? Try them both and compare differences. Whatever error you get...

Thanks for the "Job Configuration" tip. Was confused about using it because I thought it was only for the NADCON conversion.

Got it. You have to select it from the New Job wizard. You can select WGS84 XYZ in the last tab of the wizard. Once selected I can't find a way to swi...