I would share all of your anger if this was actually preventing a plat from being approved, but is it? I would rather the reviewer point out minor err...

Heavy clouds, huh?

A few days ago, he used a skid steer bucket to round up all of the junk and tore out the bar by accident. The old fellow wants to put a bar back wher...

Apparently the only recourse would be to go Court to have him remove his pin which he stated. Don't you have a State Board of Registration or Licen...

IMHO, the question should be posted on an Attorney forum...

In such a case the law seems to be well settled that the survey upon the ground as ascertained by monuments then made to mark the boundaries of the lo...

Another option would be to create your point group, then navigate to the Toolbox tab of Toolspace. There you will find Reports Manager, with a Points ...

The one quarter corner common to Section 25 and Section 36

Parallel with the west line and north are the same thing, thus, that leaves parallel with the east section line. The manual being used in the 1850's ...

Morasse caps - we have EXTREME UV here and they look brand new after 45 years. It's almost impossible to remove them from the rebar

@olemanriver I would pose these questions on one or more of the AutoCAD Civil 3D forums/sites.

"In my part of Upstate New York the record dimensions rule, so we show the monuments refenced to the record." Please elaborate - in 50+ years of prac...

I think this issue is discussed in the BLM Manual

Be very careful of the Supplemental plans - many are not what they seem to be. I would advise a great deal of study including checking to see if there...

@jitterboogie?ÿ I had a Crew Chief who would make me read the rod to 3 decimal places, do all the calcs to 3 decimal places, and write the elevations...