I prefer leading zeros.

UCS enter 3 enter Pick 2 points on the X axis then a third in the direction of positive Y dducs and name your new UCS In the viewport, PLAN enter ...

@chris-bouffard chris, check out 13:40-9.1 and 13:40-9.2 (c) A licensee engaged in any of the following acts or practices shall be deemed ...

All office work is done in my home office since 2020. The field work is done by me in the field. With technology widely available it is easy. I very o...

1.2gb is pretty small by today’s standards.

I was having a trouble one day when a friend taught me how to back a trailer...simple put your hand on the bottom of the steering wheel, hand goes rig...

Haven’t done RTK but tested PPK, short story…still need GCPs. PPK might screw it down to a foot or two but that’s about it. Any chance you have ...

I hardly ever use my total station anymore. I'm at the point where I go on entire trips without it, it’s just in the way, the box in the truck with t...

I thought I felt a rip in the force.

In the woods sometimes we tie flagging to the pipe and up to a tree branch to make the location more visible especially when setting up control. Not i...

It looks good but how efficiently can you extract usable data from it? surpringly fast and accurate. I did my deck, 20.45 feet tape measure is 20.6...

It gathered 181 images automatically as I walked around the table.

That’s a CAD issue. Don’t have a fix for it so I live with it.