I was always told that I was one of the few that even ordered image manger.?ÿ I don't think that I am willing to give up the USB ones, but, you can co...
What modules do you need on the dongle??ÿ Do you car if they are parallel port?
Loyal, I'm with on all that you mentioned except mineral surveys, but, I can add mm and cm for 3D printing.?ÿ and then there are the unofficial nudges...
Cyclone also has the cubic spline option to create a pline that matches the actual very closely I did clean the data several times by trimming edges
@summerprophet I placed a 3D model of that part in the model thread last January
If only 15 foot high rods were not so unwieldy, we could solve that one
I have seen this technique before and it fails if the stations are not broken in height significantly, as said above.?ÿ Basically if the wrong foot is...
The only item that I would add to Jim's comment is that you should have a decent idea of where the plates are and make an attempt to measure your site...
Noted, if I hear anything down here I will call you
I am with you on that, I just don't see how there are that many people that make it worthwhile. We are with Nate at 10 or more per day
I took one home this weekend to see if I could determine the signal with an oscilloscope (that was a dismal failure, I will get back too) and I took t...
Great screen name sir!
All of my surveying is in feet with a few GPS generated meters and then all of my CNC and 3D printing is in millimeters. I have no use for inche...
This is the S6 active target and I have always wondered why the ring of LED's on top when there is clearly one sensor on the instrument
Shu, what you are doing is awesome! Old Geodimeters/Trimble instruments have the quad photodiode for tracking the IR transmitter mounted below the opt...
Oscilloscope ordered and I have to stay off my knee for a while according to the doc, so, sitting by the lake learning electronics ...?ÿ?ÿ This is goi...