Geodimeter 600/Trimble 5600 Accessories

I'm looking to sell the autolock prisms, carbon fiber rod w/ powerstick, and accessory cables that I used until recently with a Geodimeter 600 we traded in. As far as I know, these prisms and cables should work fine with a Trimble 5600. In fact many of these pieces have Trimble part numbers for the 5600 instead of the older Geodimeter 600 we were using them with. Here is what I have for sale:

1 - 360 Degree Mini Prism - Pt. No. 571204312 - This screws on top of the Remote Target and has a 2 mm prism constant.
1 - Remote Target 606, 360 degrees - Pt. No 571202220 - This is powered by the power stick which is in a section of the rod.
1 - Telescopic Power Rod with adjustable collar, dual graduated (m/ft) - Pt. No P71560005MFT - This comes with a carbon fiber rod, the powerstick, the charger (which can also double as a Dini/Zeiss charger with the correct cable), a powerstick charging adapter, and a charging cable for the powerstick.

2 - Remote Targets w/ 0mm prism constants - Pt. No. 571202220 - These are powered by 2 AA batteries.
1 - Tilting prism bracket - Fits the remote target so you can tilt it up and down.

3 - Data collector controller cables - These plug into the 600 or 5600 for external communication. One end is a circular connector with 4 pins and the other end is a serial port db9 plug that goes into a data collector.
1 - External battery cable - Pt. No. 572202326 - One end plugs into the external power port of the 600 or 5600 and the other end has alligator clips for a negative and positive battery terminal.

Here are some accessory documents showing the parts listed above:

Trimble Part No.
Geodimeter Part No.

I tested the parts as well as I could without having a physical total station to use them with. All the prisms autolock functionality seems to work, they power on and associated led's blink. I believe the powerstick was re-celled in 2008 and was used only a few times. It's batteries hold a charge. The condition of all the parts is used. I would say everything is in fair condition. Everything has it's fair share of bumps and scratches, but is in fully functioning condition and complete.

If you are still using a Geodimeter or Trimble 5600 and are looking for some extra/spare parts please send your offer to the email address associated with my profile. I will answer any questions to the best of my ability in this message thread. Thanks!